Search results

Are you referring to the numbers on each section of the coils? If so 3-26/36 would mean it's 3 cores of 26AWG wire wrapped in 36AWG on the tri-core Fused Claptons, on the framed staples 2-28/4-.1*.3/36 would mean there's 2 round wire "frames" that are 28AWG, in between those are 4 pieces of...

The Slick Strawberry Milk is amazing, boosted through a 120ml bottle in 4 days, it's that good.

Vouch for @Dela Rey Steyn, good luck with the sale buddy, it's for a great cause and there's some stellar deals.

Tried many different coil positions and this for me was the best, in theory the air pressure builds up beneath the coils, engulfing them completely, bringing all the flavor particles up. Also having the coils closer to the airflow ports makes the draw tighter

It won't really affect the vape if the cotton is thinned out enough. Mine sits just behind the cotton retaining ring with a few stragglers peeking through.

Before I rewick my Reload RTA, I thought I'd share some pics of my preferred coil positioning.

All systems go. So far I can say it has amazing flavor, using Mr Custard, Custard Surprise (banana custard). Installed Nano Fraliens, running at 30% on my NCV2 in series mode. Impressed with the flavor and draw, very rich, smooth, saturated vape experience. Still early days but the build deck...

Can anyone tell me if the pc bubble tank holds up with tank cracker juices? I see the 2ml glass being a problem for me.

Picked up 1 today from Vape Odyssey, can confirm they have about 3 left, SS and black available. Now for my questions, 2.5mm or 3mm coils? Coil placement? Is the PC bubble tank tolerant of acidic juices?

Check your pm bud

They're great performers, the ribbon, frames and outer all heat up different, and gives this layering effect on the flavor

Some special babies I put together for my Reload. 2x 28AWG frames, 4x 0.3mm ribbons stacked, 36AWG alien wrap, 3mm ID, 6 wrap, all N80. Now to install them.

@ace_d_house_cat also bear in mind, too high will make your wicking suffer a bit as it's a long way for the juice to travel, this way I get the bottom 3rd of the coils to line up with the top of the airflow nub thingy

Legs were cut at 4mm here but coils weren't positioned towards the center as yet. Pulling them to the center will bring them higher as it's more of a straight line in relation to the post holes

Most people cut them at that length, at 4mm its perfect for me because I pull the slack out completely that the 3mm rod is snug and has to be rotated to remove from the coil, something about slack coil legs troubles me . But if you don't mind that, the 6-6.5mm should work fine

A good set of Nano Aliens, 3x 28 or 29AWG cores, with 36 or 38AWG outer, N80, 3mm 6 wraps. Should be around the 0.17-0.20ohm mark. Cut the legs at 4mm, install flush on the deck while screwing the legs secure, with the 3mm coil rod in the coil. Once secure pull up, till the slack is gone and the...

On hold

No sir, looking for a sale only

The 26 was very restricted, worked best with 2.5mm ID coils, pushed to the side, very hyped up tanks but when it was released most people sold them after a short time of using it

Having tried the Arbiter as well, it's great but the height of the deck makes the wicking a lil slow, I'm sure with some patience you could get it perfect but basic to basic the Reload 24 wins, Reload 26 was a fail IMO