Search results

Yep there has to be cotton in the wicking channel. I leave a bit on the deck. Mine has never leaked, it does however "sweat" a little around the air slots, but its minor. I run SS 10 wraps at 3.5mm. Works out around .5 ohm. Never had a dry hit or leak

I'm another bearded vaper. Had the beard for 10 years or so therefore not related to vaping. No hair on the top of my head though ....

Consumer Protection Act forces them to sort it out. They cannot pass the buck to the manufacturer. Name and shame please to protect the rest of the vaping community

Actually no. I took a chance and just blew out the very small amount of filings that went in. 99% of the filings go up anyway.

I took one of my "dud" coils and carefully applied a small Dremel rotary burr to it. Put it in the Cubis and - Perfect. this was a coil that would only juice up on installation and within about 4 to 5 hits started going dry. Gave it a a good working out last night - long lung hits and no hint of...

I will have a go over the weekend. Hope my hands are steady enough!

I have had 2 coils that only wicked when they were installed. Seems that there are some coils that have excessive movement on the centre pin which blocks the juice flow completely, or the seal expands too much. Will do the mod on all new ones - might try to Dremel a gap on the side of the juice...

For the Serpent is a hands down winner as an all round tank. It has good flavour, vapour production and is not as thirsty as the Griffen, Crius and TVF4. the build is easy and it has a working and easy to use juice flow and air control.

PM sent