Hey @Spyder1984, hope you're doing well... With regards to cleaning coils; you should let them cool after dry-burning them and before cleaning them with water and a toothbrush. Radical temperature changes are not good for the metal.
You also shouldn't dry-burn stainless steel wire as it alters...
Hey @CJB85 - hope you're well man... FLV Chocolate Deutsch sounds like the closest flavour in writing. Can't speak from experience but yeah...
CHOCOLATE FT. CONCRETE RIVER [ NOTED: EP. 73 ]
Bakers Flavors Chocolate Truffle
Dry, but a really good chocolate, just hard to get ahold of. There is...
Haven't tried Lucky Leprechaun but ELR notes say a cereal marshmallow flavour (oats). That recipe also uses very little at 0.4%.
Maybe 0.2% TFA Honey Circles Cereal for the oats note and then either some FA Marshmallow at 0.2% or FA Meringue & TFA Toasted Marshmallow both at 0.2%
I'm just...
I can almost guarantee @Rude Rudi is using a flavour banger RDA and not a RTA. Most experienced mixers use drippers for accurate reference flavour. I personally use my RDA for testing and my RTA for everyday vaping.
Using a RDA will increase saturation but its not always the most practical or...
I DIY too so can't give accurate comment but it's safe to assume 10ml is a fair average consumed by your general vaper...
Assuming this;
10ml x 30 days =
300ml / 60ml =
5 bottles =
5 x +/- R220 =
R1100 per person per month on average...
Are you using TC capable wire?
Only SS, Ni200 & Titanium can be used in TC mode. Maybe some other exotic wire types too but Kanthal and Nichrome are meant for wattage control...
I guess this could be argued as being subjective... Some people say max VG is great. Other people say it does impact flavour marginally. I haven't tested enough to really say. Main reason for higher PG ratio in my books would be for viscosity and wicking reasons.
Need to mix the same juice at...
It works... Much of a muchness in my opinion. It obviously comes out at varying VG/PG ratios based on how much PG the flavourings add to each recipe. I mix at 70/30 and sometimes mix 60/40 or 50/50 for MTL juice so I prefer having my components separate. The differences are negligible... Pre-mix...
@FireDragon - I'm not sure what nicotine you're using but I found this article which should set your mind at ease a bit. Maybe you're already vaping your mixed juice and don't care anymore :p
https://www.theflavourmill.co.za/products/nicotine-salts
If you recoil at 1.0 ohm or above I'd recommend trying it at 9mg first... 3mg-6mg higher than your preferred freebase strength. 12mg would be doubling in your case so I'd say 9mg is a good bet provided it's not being sub-ohm vaped. MTL might serve you better for super-ohm if you have such a setup...
I have spoken to the guys at BLCK Vapour about sub-ohm vaping nic salts before and they said they don't have nic salts intended for that use.
They said they can import the right thing but it's significantly more expensive than the super-ohm safe nic salts.
If the catalyst for converting the...
I'm vaping on a dual coil Hugsvape Lotus RTA with Lightning Vapes clapton wire. 26g SS316 core with 36g KA1 outer wrapping. 2.5mm ID - 6 wraps reading at 0.26 ohms. Vaping at 75W...
I use the same wire and make a 3mm ID 4 wrap parallel coil for my Vapefly Pixie. Comes in around 0.21 ohms and I...
Hey @Stranger, hope you're well!!
Do you use menthol and/or koolada in all of your mixes?
The TFA Sour could also be muting this example recipe... It's not the best additive. It generally does more harm to a mix than good...
What nic are you using? Do the juices taste bad or are they just...