Best wire setups for Crius & Tsunami

herb1

Experienced Vaper
LV
30
 
Joined
11/4/16
Posts
337
Awards
18
Age
46
Location
Cape Town
Hey y'all

Looking for best flavour and moderate clouds

Which wire should I be using?

Advice is appreciated ;);)
 
For the Crius
26g Kanthal
2.5mm ID
7/8 wraps
i prefer it to be spaced but compacted works just as well.
 
26g SS316
2.5mm ID
7/8 wraps
I prefer spaced in temp mode but you can build compressed coils, your preference.
 
Ok, i got that 26g kanthal build, started off with 7 coils, now up to 8, all compressed
How would spacing affect performance in terms of flavour or clouds?
 
Tsunami:
24g SS316
3mm ID
14-15 wraps

single coil = about .50ohm
 
For the Crius
26g Kanthal
2.5mm ID
7/8 wraps
i prefer it to be spaced but compacted works just as well.

I agree with @skola on this one! I have also had a lot of success with 26/32 claptons, 3mm ID, 4.5 Wraps on my Crius.
 
For the Crius
26g Kanthal
2.5mm ID
7/8 wraps
i prefer it to be spaced but compacted works just as well.
What would be the max wattage for such a build?
I notice that I get burnt hits after 35W?
 
What would be the max wattage for such a build?
I notice that I get burnt hits after 35W?

Wicking is key... Besides the usual, "there mustn't be too much tension when pulling the cotton through the coil that is pulls the mod down", your cotton must not cover those wicking circles completely, the wicks must sit slightly above those holes.
Check @Silver wicking here
http://www.ecigssa.co.za/crius-v3-coils-and-wicking.t24426/#post-388619



Sent from my iPhone using Tapatalk
 
What would be the max wattage for such a build?
I notice that I get burnt hits after 35W?

Oh and to answer your question, if I remember correctly I used to take it up to about 40/45...


Sent from my iPhone using Tapatalk
 
Oh and to answer your question, if I remember correctly I used to take it up to about 40/45...
Sent from my iPhone using Tapatalk

Confirming the above, currently using the following:
0.28 ohm dual coil 2(SS316 7 winds 2.5 ID 26g) on TC at 40W. Good to 210 degrees but I believe could improve on this by following above wicking advice. Will try this next time round.

Thanks @skola
 
Last edited:
Back
Top