Cana problems

Michaelsa

Nicotine Connoisseur
LV
25
 
Joined
16/9/14
Posts
373
Awards
20
Location
Cape Town
Hi all.
My hana clone's screen is blank with a fully charged battery installed.(does not respond in any way)
If I put the hana on charge the screen turns on, however when the power button is pressed the screen goes blank and nothing happens.
Any help will be extremely appreciated.
Many thanks.
Michael
 
If you do not come right , I will buy it from u . i got a spare sx350 chip that i can put in the box
 
Sounds like you put it in Stealth-mode, possibly accidentally.
Also, possibly locked while in Stealth-mode?

Yeah dunno, sounds like it might be an issue. No idea unless you take it to someone who can diagnose it properly.
 
Have you tried to check if the chip repsonds to button commands? Try pressing the fire button quickly five times, it should show that the device is locked on the screen.


If that works and it does, then maybe what @WHeunis suggested might be the case with the stealth mode. You can turn that of by putting the device in locked mode then holdig the fire and - buttons till it shows that normal mode is active.

Hope this will help you out and that it is not screwed. Good luck!
 
I don't know the Cana, but shouldn't it still fire the atty when in stealth mode?
 
I am beginning to think it is stuffed. It does not fire at all.​
 
I'm going to assume you've tried the following:
Remove the battery (if possible try a different battery)
try a different atty and or coil.

After removing the battery try pushing the fire button for 3 seconds then release for 3 seconds (do this 3-4 times),
leave the device without the battery for about 30-60 minutes and then do the 3 second fire before putting in the battery again.
Its a long shot but maybe it helps.
 
Back
Top