High Gauge (super thin) Kidney Puncher Nichrome

[ShaneW]

Looking for some really high gauge (super thin) Nichrome wire?
Juicy Joes now stocks 44g, 50g and 54g Kidney Puncher wire.
Take your staples to the next level !!!

 

[Smoke_A_Llama]

54 .... can you even see it off the spool ?

 

[ShaneW]

54 .... can you even see it off the spool ?

Have a look at the photo above... can you see it? 0.016mm, thats 3-5 times thinner than the average human hair!

 

[Kalashnikov]

If you cant see it. does it even really exist?

 

[ddk1979]

@ShaneW , any news about the
- Vandy Vapes Superfine MTL fused clapton Ni80 wire ???
- Vaping Giant (Canada) thick battery wraps ???

.

 

[franshorn]

I just thought my monitor was dirty...

 

[ShaneW]

@ShaneW , any news about the
- Vandy Vapes Superfine MTL fused clapton Ni80 wire ???
- Vaping Giant (Canada) thick battery wraps ???

.

Unfortunately none of my current suppliers stock these, will keep searching though as I would love to stock the Vaping Giant wraps.

We stock the Bearded Vapers nano fused claptons which might suit your needs:
http://juicyjoes.co.za/?product=nano-fused-clapton-nichrome

 

[Andre]

Unfortunately none of my current suppliers stock these, will keep searching though as I would love to stock the Vaping Giant wraps.

We stock the Bearded Vapers nano fused claptons which might suit your needs:
http://juicyjoes.co.za/?product=nano-fused-clapton-nichrome

Ah, those are in my preferred resistance range. ID please @ShaneW?

 

[ShaneW]

Ah, those are in my preferred resistance range. ID please @ShaneW?

Hi Andre. They are 3mm ID

 

[ddk1979]

Ah, those are in my preferred resistance range. ID please @ShaneW?

@Andre , I bought a set. They are 3mm ID.

This is part of my post in the Coppervape Skyline Discussion thread.

"I rewrapped the 29gx2/38g Ni80 fused clapton so that it now has a 2.5mm ID.
I first heated the 3mm ID coil and then I carefully unwrapped it using my coil jig. Then I rewrapped around a 2.5mm mandrel following the curve of the wire (caused by the initial wrapping) to try and prevent undue tension and possible snapping of the outer 38g wire.
The new coil has a resistance of 0.69 ohms. Initially I was only going to do 6 wraps but I was a bit concerned about the resistance possibly being a bit too low so I did a 7 wrap one."

.

 

[ShaneW]

Also they are 0.71 ohm per coil so if you are running dual they out at around 0.35ohm

 

[Andre]

Also they are 0.71 ohm per coil so if you are running dual they out at around 0.35ohm

Thanks @ShaneW. Yip, around 0.7 ohm + single is what I am looking for, but 2.5mm ID for my ceramic wicks. Not a train smash though as I have some of that VandyVape Superfine wire.

 

[zadiac]

I found that wrapping with such thin wire (I use 40g) is that the coils gunk up way faster than with lower gauge wire (36 and 34). I'm only using 35 gauge once this 40g spool is done.