Ijust2 battery help

[Nightwalker]

What range can I safely build coils in the ECR coil.
Stock coils are 0.3 and 0.5
Now I'm as thick as two bricks when it comes to the working out.
The ECR coil is 1ohm precoiled, but says don't use on ijust mod. Recoil before use....
So I take it, 1ohm is to high.
Then what's to low?

 

[blujeenz]

Then what's to low?

Below 0.3 ohm

 

[Nightwalker]

Below 0.3 ohm

The new occ coils are 0.15 I think. Could be very wrong.
But OK aim for no lower than 0.3 but highest safest ohms?

 

[WARMACHINE]

ÍMO I wouldn't go as low as 0.3. That is 14 amps on a fully charge mod, not sure I trust it at that current. I normally only play with 0.5, keeping the current under 10 Amps

 

[blujeenz]

highest safest ohms

Thats not a thing.
Merely that the higher you go the less heat and thus less vapour will be produced.

 

[Kuhlkatz]

I just popped a Taifun GT II on the iJust2 battery. Coil is measuring in at 1.9ohm, and it fires fine. Cannot see why a 1 ohm should be a problem as the 0.3 ohm are the lowest stock coils for the device. I would not go below 0.3 with the iJust2 and only use the 0.5ohm coils myself.
The 0.15 ohm sounds like Ni coils, as that is the most common value for single-coil Ni meant only for TC devices.

Just remember that there is an older iJust and the iJust2. The iJust supported 18350 and 18650 batteries with standard coils of 1.6 ohm and 1.8 ohm. The warning is likely for the iJust when using the 18350 battery.

 

[Nightwalker]

Haha guys, I screwed around with my avocado rdta and popped it on the ijust2 mod. It works. Oh my hat

 

[Nightwalker]

They say pics or it didn't happen so.

 

[Nightwalker]

No standard drip tip. I like the glass one