I hope someone can help me. I've been vaping DTL primarily for the past 2-3 years, but recently started MTL more.
What I'm experiencing however, is that the flavour in my MTL setup is so intense that I feel the need to dilute the juice, but don't know by how much. Hoping someone can give me a rough starting point.
DIY mixes in DTL RTA and RDA is perfect, but as soon as I use the same flavour percentages for MTL, the flavour is so overpowering that it feels as if I am drinking the juice and not vaping it. I almost get sick after a few hits.
For DTL mixes, I use 70/30 VG/PG @ 6mg.
For MTL mixes I use 50/50 @ 12 - 18mg.
My primary DTL setup is Zeus X with dual SS316L fused claptons (total 0.3 ohm) at 40-60w.
My MTL setup is Drag X with RBA coil - 28ga Ni80 (1.2 ohm) at 10w.
I know this goes against all reasoning because the same juice at 40-60w on dual fused claptons should (as I understand it) produce more flavour than on a single round wire coil at 10w, but I experience quite the opposite.
Where do I start with diluting the juice? 10%, 20%, 50%?
What I'm experiencing however, is that the flavour in my MTL setup is so intense that I feel the need to dilute the juice, but don't know by how much. Hoping someone can give me a rough starting point.
DIY mixes in DTL RTA and RDA is perfect, but as soon as I use the same flavour percentages for MTL, the flavour is so overpowering that it feels as if I am drinking the juice and not vaping it. I almost get sick after a few hits.
For DTL mixes, I use 70/30 VG/PG @ 6mg.
For MTL mixes I use 50/50 @ 12 - 18mg.
My primary DTL setup is Zeus X with dual SS316L fused claptons (total 0.3 ohm) at 40-60w.
My MTL setup is Drag X with RBA coil - 28ga Ni80 (1.2 ohm) at 10w.
I know this goes against all reasoning because the same juice at 40-60w on dual fused claptons should (as I understand it) produce more flavour than on a single round wire coil at 10w, but I experience quite the opposite.
Where do I start with diluting the juice? 10%, 20%, 50%?