hey there so I don't have a charger for my 18650battery for my mech , my buddy lent me a box mod its a Dan 40hcigar to charge my battery with until I get my charger I popped the battery in n put it to charge but the voltage reading stays at 0.0yet the battery indicator is full , any thoughts on this I bought the mech with this battery n it was fully charged on recipt iv used the mech for like 5mayb 6toots off the mech but haven't been using the mech much n took out the battery could it be that the battery still has a lot of power on it so the indicator shows full , I'm kinda lost here not much experience with batteries
Power struggle
- Thread starter kelly22
- Start date
The voltage reading will give you a value when you fire it. After 5 toots the battery should still be almost fully charged.
Put it on charge, the mod will stop charging when the battery is fully charged.
the battery bar indicates how full the battery is. The 0.0 does not indicate the voltage your battery is at, rather it indicates the voltage you're vaping at. Without an atomizer on the mod, there won't be any voltage so 0.0 is 100% correct. Your battery is full. Vape it.
as per Yusuf
Your first mech and rda bud? How does a fully charged battery feel
what is the resistance of your coil?
Is it clean (not gunked up).
And when you experienced a "full" battery; was it with this same RDA and coil and Mech?
Is it clean (not gunked up).
And when you experienced a "full" battery; was it with this same RDA and coil and Mech?
Well unless its a perception issue or really a dud battery; It could be a lot of things.
a different juice?
Whats the resistance of your coil? and has it been changed;
is the coil gunked up? Is it screwed is it making perfect contact / screwed in tight / screws haven't cut through the wires.
The atty could be making poor contact [causing a voltage drop]
(check if there is an adjustable centre pin on the atty or mech and fiddle with it);
I had this issue often with my paragon mech cause its got a shitty screw as a center pin that needs to be adjusted to the atty used. Or if I swapped between a flat top or a button top battery.
It would sometimes still fire, just weakly if there wasn't perfect contact.
Taking your battery out & back in might have affected how tight its making contact.
a different juice?
Whats the resistance of your coil? and has it been changed;
is the coil gunked up? Is it screwed is it making perfect contact / screwed in tight / screws haven't cut through the wires.
The atty could be making poor contact [causing a voltage drop]
(check if there is an adjustable centre pin on the atty or mech and fiddle with it);
I had this issue often with my paragon mech cause its got a shitty screw as a center pin that needs to be adjusted to the atty used. Or if I swapped between a flat top or a button top battery.
It would sometimes still fire, just weakly if there wasn't perfect contact.
Taking your battery out & back in might have affected how tight its making contact.
Last edited:
Similar threads
