Battery Safety??

[rogue zombie]

If you run it in power mode at 40W then the mod reduces voltage to 3.16V which means the current will be 12.65A, so safe for the batt but a limited run time of 16min giving 186 puffs, with the 3100mah batt as baseline seeing as they didnt have your batt listed.

Running your batt in any unregulated mod with a .25 ohm coil will be on the ragged edge, expect heat.

Huh, I didn't even notice that. I see the volts is around 3, so I must be in power mode.

Sent from my SM-G920F using Tapatalk

 

[shaunnadan]

Huh, I didn't even notice that. I see the volts is around 3, so I must be in power mode.

Sent from my SM-G920F using Tapatalk

Your mod has power mode (for kanthal usually ) tc modes and then bypass mode.

Bypass is where it was "act" as an unregulated mod and push all battery power through to the atty but I have yet to see a mod that goes past the electronic boundaries that the mod can handle .

 

[rogue zombie]

Your mod has power mode (for kanthal usually ) tc modes and then bypass mode.

Bypass is where it was "act" as an unregulated mod and push all battery power through to the atty but I have yet to see a mod that goes past the electronic boundaries that the mod can handle .

Lol... I actually read a manual, to see what's happening

I think I may actually look into TC.

Sent from my SM-G920F using Tapatalk

 

[rogue zombie]

Although, I haven't really seen much folks actually excited about TC.

Sent from my SM-G920F using Tapatalk