Coil advice needed

Chad B

Noob Vaper
LV
3
 
Joined
14/5/16
Posts
19
Awards
3
Age
28
Location
Cape town
hi guys I'm new to vaping so I need some advice

I purchased the 0.35mm notch coils for my twisted messes v1 RDA

I'd like to know at which wattage do I fire them after installing as I tried previously and the coil broke in half(broke at 60watts after a 3 second pulse)

It's a single coil ohms are reading at 0.13

Will be using it on the joytech cuboid 150w
 
Last edited:
Provide a bit more info please. Single or dual coil. What are the ohm readings? Notch coils are meant to be single coils. Dual coils will get the ohms to below .1 ohms, which is not advised, especially if you're new to vaping.
 
Provide a bit more info please. Single or dual coil. What are the ohm readings? Notch coils are meant to be single coils. Dual coils will get the ohms to below .1 ohms, which is not advised, especially if you're new to vaping.

It's a single coil and the ohms are reading at 0.13
 
It's a single coil and the ohms are reading at 0.13
Did you pulse the coil for 3 seconds at 60Watts before or after installing cotton? I am assuming before? Might be way to high wattage for dry firing for 3 seconds at a build that low. I would suggest dry burn or pulse at 12 - 20 watts for 3 seconds at a time
 
Try pulsing them at a much much lower wattage.

Sent from my D2533 using Tapatalk
Pulsed at 20watts and it fires properly

Thanks for the advice

Will upload a picture shortly
 
Not sure if it's enough cotton but it smokes fine,nice flavor and Vapour production
 

Attachments

  • image.jpeg
    image.jpeg
    105.6 KB · Views: 42
Not sure if it's enough cotton but it smokes fine,nice flavor and Vapour production
Nice. Looks good, you will know very quickly if the wick isn't right trust me. From here on out its all about that experiments . Have fun

Sent from my D2533 using Tapatalk
 
Back
Top