Can get started on mk2.
Swiych is rated at 3a so I will be fine above 1.0 ohm.
Swiych is rated at 3a so I will be fine above 1.0 ohm.
Diy 18650 Box Mod
- Thread starter Necris
- Start date
Can get started on mk2.
Swiych is rated at 3a so I will be fine above 1.0 ohm.
No, minimum 1.4Ω (R = V/I → 4.2V/3A = 1.4Ω
Duly noted,my calculation was done at 3.7v
have been coiling around 1.5-1.7 on the 3d dripper for the MVP so we should be fine.
remember this battery isnt final version either,its a R60 ultrafire knockoff im using for sizing and general prototyping.
so much so I refuse to actually buy a charger for the 18650 until i have a vtc4/5 to use.
Will keep an eye out for a higher Amp rated fuse
Mk2 going well, damn battery holder is beating me for now, but in concept it works.
Put simply, my skills are insuffiecient and this box is too small for this 18650 and safely done contacts
Put simply, my skills are insuffiecient and this box is too small for this 18650 and safely done contacts
Mk2 going well, damn battery holder is beating me for now, but in concept it works.
Put simply, my skills are insuffiecient and this box is too small for this 18650 and safely done contacts
Much better that this emergency setup
That is scary as hell........
science always involves risk....That is scary as hell........
aka .. taking one for the team
Have gotten lazy and spoilt with mech mods, will get back on this soon
Similar threads
