Gas mods kree rta

[Ryan69]

Got this kree rta no issues with wicking but every time I fill it and replace the drip tip it pisses juice out of the air flow port. What am I doing wrong

 

[Paul33]

I’ve never used a Kree Rta but I would guess that if you cover/close the airflow when refilling it will solve the problem. Sounds like a change in pressure issue.

 

[Paul33]

So did it work or am I not as clever as I have been told I am?

 

[Ryan69]

It worked so so still had a little bit of leaking

 

[Ryan69]

Ok my next move was to take a piece of tissue and stick it in the air flow hole while closing it so far that has worked the best

 

[Paul33]

Its a very weird problem to be having. what if you wait till the tank is EMPTY EMPTY before filling up?

 

[Ryan69]

I'll try it that way let's see what happens

 

[Ryan69]

Ok guy I've done different builds 2.5mm / 3mm different air flow pin and every time I've filled the tank I've observed when replacing the drip tip locking nut pressure forces the juice down

 

[SteamServant]

Ok guy I've done different builds 2.5mm / 3mm different air flow pin and every time I've filled the tank I've observed when replacing the drip tip locking nut pressure forces the juice down

Could you try something like filling it 3/4 of the way, then screwing on the tip just barely enough to make a seal, flipping it upside down, then tightening it completely? That way the increased pressure won't be able to squeeze juice through the wick? Never used this rta before just an idea