Haywire twisted 24g ni80

[MrSoomar]

Sup guys,

Just was wondering if anyone at all knows how to use Haywire twisted 24g NI80???

I cannot for the life of me get a build that works!!

I tried 6 wrap 2.5mm dual coil and the mod refused to fire coz it was 0.06 ohms hence too low. Im baffled

Any build recomendations would help!

 

[Rafique]

I get about 0.25 on 8 wraps 3mm I think

 

[MrSoomar]

I get about 0.25 on 8 wraps 3mm I think

On a dual build?

 

[Rafique]

nope single, I also bought this wire not realising how low the resistance will be. so on a dual it will be .12 to .15

 

[MrSoomar]

nope single, I also bought this wire not realising how low the resistance will be. so on a dual it will be .12 to .15

Lol yeah it was looking good not realising its going to be so low,

Tell me do you dry fire it before u wick it? Also do u fire it in wattage / power mode? Or TC?

 

[Rafique]

yes I do around 20w first and then move up. I use wattage not temp

 

[MrSoomar]

yes I do around 20w first and then move up. I use wattage not temp

Perfect thanka for your help! Ima try it again this afternoon

 

[Moey_Ismail]

Perfect thanka for your help! Ima try it again this afternoon

Just remember your pre fired coil resistance can be as much as half of what post fire will be. So if your mod can't read very low and using a dual coil setup, dry fire each coil on it's own

 

[DamienK]

This stuff is wicked... when they say low resistance wire, they really mean it! I am running dual 5 wraps 3mm ID and they read at .18ohms..