Hi All
Is there any benefit of the one over the other at the same Power?
Lets take a simple example on some of my equipment with standard coils.
Scenario 1
Kanger Protank 2 standard coil - 2.2 ohm
Voltage on my Vision Spinner batt - 4 Volts
Power - 7.27W (V squared/R)
Scenario 2
Kanger Protank 2 standard coil - 1.8 ohm
Voltage on my Vision Spinner batt - 3.6 Volts
Power - 7.2 W (almost identical to above)
In theory, surely these two scenarios should give the same vape, all else equal?
However, I calculated the current for each scenario. I=V/R
Scenario 1 - 1.8 amps
Scenario 2 - 2 amps
Does the higher current (even though the same power is being used) make any difference? Surely the heating of the coil should be the same though?
I havent done side by side tests, since I only have one Protank. But I dont really notice much difference with the different coil. Then again, its hard for me to compare.
PS: I did see something about this somewhere on the forum. I think Matthee discussed it somewhere else. Apologies if this is repetition, but I think its a worthwhile topic to have a thread of its own
Is there any benefit of the one over the other at the same Power?
Lets take a simple example on some of my equipment with standard coils.
Scenario 1
Kanger Protank 2 standard coil - 2.2 ohm
Voltage on my Vision Spinner batt - 4 Volts
Power - 7.27W (V squared/R)
Scenario 2
Kanger Protank 2 standard coil - 1.8 ohm
Voltage on my Vision Spinner batt - 3.6 Volts
Power - 7.2 W (almost identical to above)
In theory, surely these two scenarios should give the same vape, all else equal?
However, I calculated the current for each scenario. I=V/R
Scenario 1 - 1.8 amps
Scenario 2 - 2 amps
Does the higher current (even though the same power is being used) make any difference? Surely the heating of the coil should be the same though?
I havent done side by side tests, since I only have one Protank. But I dont really notice much difference with the different coil. Then again, its hard for me to compare.
PS: I did see something about this somewhere on the forum. I think Matthee discussed it somewhere else. Apologies if this is repetition, but I think its a worthwhile topic to have a thread of its own