Icon RDA by Mike Vapes

[Rude Rudi]

Broken in the middle? This is a long shot, but can you send a pic or explain it differently?


Sent from my iPad using Tapatalk

 

[Hakhan]

Broken in the middle? This is a long shot, but can you send a pic or explain it differently?


Sent from my iPad using Tapatalk

Binned it already. But literally as I pulled one end of wick it just came out ..no tension. Same on the other side. It almost seemed that the wick disintegrated in the middle of the coil.

 

[Hakhan]

Binned it already. But literally as I pulled one end of wick it just came out ..no tension. Same on the other side. It almost seemed that the wick disintegrated in the middle of the coil.

3id 7 wraps ni80 flatware coming out at just over .2ohms surprisingly vaping very well at 43W

 

[Rude Rudi]

Sounds like your wicking may be a tad too thin but your pictures look ok... just practice and you'll get there.
When u wick, there must be 'just enough' tension when you pull on either side - it must not be loose and it must not be 'stiff'.
Remember to use decent cotton - the staple is Cotton Bacon for dripping


Sent from my iPad using Tapatalk

 

[Chukin'Vape]

Wuddup guys & gals - please go check out my review of the Icon RDA

 

[mike_vapes]

OK so went it to buy some wire and juice and came out with this as well. ☺
How often should you drip? Probably be very subjective ...but after I drip I get about 6 to 7 good vapes and then the flavor drops off. And then probably another 10 hits with decent plumes but towards the last 5 get cotton ball mouth. But not really dry hits.
the pics below from when I drip, post drip and when the flavor taps out.

If its NI80 20g flat wire Ive been having the same problem no matter what wicking method i use no matter how thick or thin the wick it burns through in the center. buuuuuuuuuut sorted it out last night. just space the coils and u are good to go.

 

[Chukin'Vape]

Hi All, has some request on how to build the Icon Rda - so herewith the video.