Issues with pre-firing Aliens

[HvNDhF]

Hi All

Maybe someone can help or point me in the right direction.

I am using Dual Aliens that comes in at 0.12 to 0.13 ohms.

Pre-fire it comes in at about 0.06. So my mods that I currently have does not fire that low and I always have to take it in to a local vape shop to assist.

Can I fire the coils one by one?

I tried that with normal fused claptons and even when I try to fire each coil by itself I get a reading atomizer too low.

Must say it is frustrating.

Any help would be appreciated.

 

[Vape Hacker 808]

Check your post screws.

Post a picture of you coils mounted on the deck.

What mod are you using?

 

[HvNDhF]

Rage, coils are screwed in correctly and tight. Not touching anywhere.

Tried my revenger and alien as well. Same issue

Sent from my SM-G965F using Tapatalk

 

[baksteen8168]

Rage, coils are screwed in correctly and tight. Not touching anywhere.

Tried my revenger and alien as well. Same issue

Sent from my SM-G965F using Tapatalk

Maybe check if there is an offcut piece of wire shorting the deck?

 

[Vape Hacker 808]

Whats your Ohms with a single coil mounted?
Before Dry fire and after?

 

[Chris du Toit]

I take it the coils are Nichrome, if so Nichrome reads much lower pre fire. Take your coils out and torch them with a blow torch, this oxidises the metal and brings your ohms up a bit, install them and fire away to take out the hotspots.

If you dont have a blow torch, install them one by one and work out the hot spots then install them together and you will be good to go.

 

[Rafique]

what mod ?

 

[HvNDhF]

I take it the coils are Nichrome, if so Nichrome reads much lower pre fire. Take your coils out and torch them with a blow torch, this oxidises the metal and brings your ohms up a bit, install them and fire away to take out the hotspots.

If you dont have a blow torch, install them one by one and work out the hot spots then install them together and you will be good to go.

Thank you man. Will def try that

Sent from my SM-G965F using Tapatalk

 

[HvNDhF]

Whats your Ohms with a single coil mounted?
Before Dry fire and after?

Havent tried that yet

Sent from my SM-G965F using Tapatalk

 

[Vape Hacker 808]

@Chris du Toit definitely agree

 

[Dreadside]

Try spacing the coils, take the coils and put them on a jig and with your nail stretch them just a little bit so the wraps are not touching and then install them, and then you can use a ceramic tweezers to close the gaps if you want no gaps between the wraps. Had the same issue with my smok alien does not fire if the coils are below .1Ohms

 

[Vape Hacker 808]

@HvNDhF hope you sorted?