rx200 charging

Imotions

Experienced Vaper
LV
15
 
Joined
8/5/14
Posts
333
Awards
13
Location
Florida, Roodepoort
hi guys
so i need advice is it safe to charge my rx200 via usb? i never see my battery is low and charger is at home

Sent from my SM-G920F using Tapatalk
 
Get yourself an external charger and a second set of batts. that is what I did with my RX200. When charging via the usb the batteries are not charged equally. Not sure if that was fixed in the latest firmware update but it is just better to get an external charger like in Intelli Charge or Xtar 4 bay charger.
so now when one set is depleted i pop them in the charger and put my charged set in so never have a dead mod while wating for batts to charge.
 
This topic was previously discussed here
http://www.ecigssa.co.za/how-bad-is-onboard-charging.t17530/

The highlights are :

Rx200 no Balance charging
Wismec recommends external charger

If you have to charge via usb then make sure that you can leave it for sufficient time to charge (few hours undisturbed) and you should be rotating your batteries within the mod.
 
ohk thanks guys... my problem is i never see that my batteries were like almost dead and i brought it to work and i dont have the external charger with me.... if i seen it at home i would of just brought the pico and left these to charge till i get home later today.... so if i charge it just like for today will it affect my batteries badly? or can i get away with just one charge this way... i cant not be without my dose of clouds

Sent from my SM-G920F using Tapatalk
 
You will be fine for today, but chances are it'll be home-time before the batteries are fully charged. :--P
 
lol its like only 3bars full eish but luckily i dont crave as much as i used to for a stinkie... and im busy at work

Sent from my SM-G920F using Tapatalk
 
i pulled through strong as soon as i got home pico was out batts on charge

Sent from my SM-G920F using Tapatalk

Well done @Imotions
Hope you get sorted with a spare set of batts soon
 
Back
Top