Subtank Mini not sitting flush on VTC Mini

Silver

Flavour and throat hit seeker
Staff member
Administrator
ECIGSSA Donor
VIP
LV
63
 
Joined
16/11/13
Posts
43,440
Awards
50
Location
Joburg
So I got this delightful little combo a few weeks ago from Vaperite

I wanted the silver subtank mini.

But does anyone also find it doesn't sit flush on the Evic VTC Mini?

ImageUploadedByTapatalk1451759969.745265.jpg

The gap is around 1mm

Works perfectly but I would like it to sit flush if possible. I haven't screwed it down too hard. Just to when it gets quite tight. Don't want to force it further.

Any advice from the other subtank mini and VTC mini users?
 
10cr_lg.jpg
 
I have an idea

Off to the vape cave

Be right back
 
Ok, i'm back

It improved it slightly, but the gap is still there

I took out the RBA coil head and then pushed the bottom gold coloured 510 pin up so it was flush.
Then put the RBA back in and it stayed flush
But when I screwed the atty back on, there is still a gap
But at least Im moving in the right direction

ImageUploadedByTapatalk1451937884.191765.jpg
 
That's not bad @Silver if one closes one eye and squints with the other it looks quite good :p
Just kidding it looks a whole lot better - a big improvement. :--) Unless one really looks probably not noticeable.
Dave
 
Look on the bright side, the tank will never scratch your Mod. Also get a sleeve, it looks sexy and makes the gap completely invisible. :)
 
Look on the bright side, the tank will never scratch your Mod. Also get a sleeve, it looks sexy and makes the gap completely invisible. :)

Thanks @Effjh ! I do need a sleeve! You are right
 
That's not bad @Silver if one closes one eye and squints with the other it looks quite good :p
Just kidding it looks a whole lot better - a big improvement. :--) Unless one really looks probably not noticeable.
Dave

Thanks @DaveH
Lol, i had to squint while taking the photo to get it just right
I will squint at the setup from now on
 
Back
Top