Thelema Quest issue

[Miks786]

Hey Everyone

I have a problem with the battery ready on my Thelema Quest, i reads the one battery as 100% and the other as 0% (empty), I have used 3 different sets of battery with 2 sets being brand new and same issue..All batteries have been fully charged as well.

Can it be fixed or should I toss it out?

Thanks

 

[Raindance]

Hey Everyone

I have a problem with the battery ready on my Thelema Quest, i reads the one battery as 100% and the other as 0% (empty), I have used 3 different sets of battery with 2 sets being brand new and same issue..All batteries have been fully charged as well.

Can it be fixed or should I toss it out?

Thanks

Clean the battery terminals inside the mod not forgetting the battery pickup pin and contact area on the battery door.

Regards

 

[Miks786]

Thanks bud, I’ll give it a try and let you know what happens

Clean the battery terminals inside the mod not forgetting the battery pickup pin and contact area on the battery door.

Regards

 

[Intuthu Kagesi]

Clean the battery terminals inside the mod not forgetting the battery pickup pin and contact area on the battery door.

Regards

It's related to the connection between cells, and or the thin sense wire from this connection back to the PCB

 

[DarthBranMuffin]

It's related to the connection between cells, and or the thin sense wire from this connection back to the PCB

So it could be a nonsense wire problem....

 

[Miks786]

It's related to the connection between cells, and or the thin sense wire from this connection back to the PCB

Should I just clean it off?

 

[Intuthu Kagesi]

Should I just clean it off?

As @Raindance suggested, clean the contacts first, and if that doesn't resolve it then get a multimeter and check for continuity from the junction of the two batteries to the PCB ... Chinese mod manufacturers are notorious for using substandard wiring wrt both quality and grade, (aka current carrying capacity), way below what it should be.