See that little beige piece between pin and deck. That's what i'm referring to
To squonk or not
- Thread starter Jean claude Vaaldamme
- Start date
-
- Tags
- squonk
See that little beige piece between pin and deck. That's what i'm referring to
Wow thanks for all that. Yes looks like that little washer thingy is still there. I dont know what problem is, see you can change resistance on the rsq menu also, dont know how that works, I thought your resistance is determened buy your coil. Anyway havent played that much with the menus.
See that little beige piece between pin and deck. That's what i'm referring to
Was checking the svreen while power button pressing, and the ohms keep jumping, then .65 then .82 dont know. Screwed the squonk pin tight again and build a new coil now. It shows .52 ohm same as on the ohm meter, no short message yet. Going quickly to my little pincess's school for some performance, will see how it goes and report back
As far as I know the resistance settings are for temp mode when using titanium or stainless steel coils. So I suspect that your RSQ is in the wrong mode. It should automatically jump to Wattage or Power mode if thou aren't using any of those coil types.
From your solution it sounds like the coils were just not screwed down properly. (sometimes they loosen after the first pulse, dry fire)
@Jean claude Vaaldamme - excerpt taken from https://versedvaper.com/hotcig-rsq-squonk-mod-review/
To access the menu, click the fire button three times. You can use the fire button to go to the next option, and the adjustment buttons to change the settings of the current option. Some of the things you can do include:
To access the menu, click the fire button three times. You can use the fire button to go to the next option, and the adjustment buttons to change the settings of the current option. Some of the things you can do include:
- Lock the atomizer resistance.
- Change the fourth display readout.
- Change between Power, TC, and Bypass Modes.
- Hold the power and down button to change the display orientation.
- Hold the power and up button to change the LED settings.
Thanks. Yes I think the coil was the problem. Just used the coil that was in already but had to take out to put squonk pin in, so it probably did not make good connection on posts because excess wire was cut already. No problems yet with new coil
And yes, I coild atleast figure out the power mode when I set it up, the other modes confused me so just picked power
Im sexy and I know it
Even the kapoen wasp looks good now. Anyway, man I should have done this from the beginning, just so much better and hassle free.
Ok so first read the manual, then coiled and wicked the Troll v2 I got with it. Just to fnd out that the Troll is not bottom fed, with no squonk pin. Ok so then got the wasp ready.
Put on fill bottle and there you go, what more would one like.
So I thought I must get an rdta that will be easier not to over squonk, specially with the wasp having such small deck for liquid. But I dont know yet, I like the small wasp nano so much on this small mod and havent had any over squonking yet. Maybe its just me, I can taste and hear when wicks are getting dry, before you get dry hit, it just taste and sound a bit different. Then squonk bottle 3-4 times. And thats good for about 10-15 hits
So yes very happy, dont think I could have bought any better.
Even the kapoen wasp looks good now. Anyway, man I should have done this from the beginning, just so much better and hassle free.
Ok so first read the manual, then coiled and wicked the Troll v2 I got with it. Just to fnd out that the Troll is not bottom fed, with no squonk pin. Ok so then got the wasp ready.
Put on fill bottle and there you go, what more would one like.
So I thought I must get an rdta that will be easier not to over squonk, specially with the wasp having such small deck for liquid. But I dont know yet, I like the small wasp nano so much on this small mod and havent had any over squonking yet. Maybe its just me, I can taste and hear when wicks are getting dry, before you get dry hit, it just taste and sound a bit different. Then squonk bottle 3-4 times. And thats good for about 10-15 hits
So yes very happy, dont think I could have bought any better.
Wasp Nano and RSQ is a great combo.
I use mine daily
Send from this side of the screen
Ok can somene explain something to me. On attached photo you have that round thing inside the 510 (think thats what its called) thats now where the juice comes through from the bottom It has a flat surface with the hole inside. Then my logic says the squonk pin sits on top of that flat surface. The squonk pin has a sleeve to be able to screw it in with flat screw driver. So if it works like that, why will juice not leak through that sleeve when juice is pumped through it and leak into your mods internals?
My best guess would be path of least resistance, but I'm no engineer so dont quote me on that
Sent from my SM-A530F using Tapatalk
Dont over think it, just squonk and enjoy
Send from this side of the screen
Thats what she said
Sent from my iPhone using Tapatalk
Well if its leaking there it will bother me permanently till I have solutionDont over think it, just squonk and enjoy
Send from this side of the screen
. And Im sure it is, because if I press small piece if tissue in that hole the tip of tissue is wet, so there is some fluid in there that will just run inside the mod
Yes I see fluid everywhere on your photosNow you have me stripping mine and looking for leaks
Send from this side of the screen
Yes check that screw on left bottom corner next to bottle, there is some juice residue comming out, that for me means its leaking there on top and filters through divice and come out there
My logic say that its designed like that to suck air in after you pressed the bottle and not just sucking the juice back. But then is can also leak there when pushing liquid through.
Think a better design would have been totally seal that part and let the squonk pin go in higher inside the deck. Then it can get its air from there and if you over squonk to a higher level that the pin goes, it will just suck the liquid back and you will never over squonk(leak)
Think a better design would have been totally seal that part and let the squonk pin go in higher inside the deck. Then it can get its air from there and if you over squonk to a higher level that the pin goes, it will just suck the liquid back and you will never over squonk(leak)
I have not read any post in this thread but i will say go for the squonk. Try it and if not for you atleast you can say you have tried.
Myself have done most of what is availible to us as vapers and for my vaping style i love to squonk. Come rain or sunshine, hot or cold weather. I know where i am happy with my vapes.
Myself have done most of what is availible to us as vapers and for my vaping style i love to squonk. Come rain or sunshine, hot or cold weather. I know where i am happy with my vapes.
Ok now that I have settled into vaping and squonking, here is the next qeustion. I see the people with normal mods and tanks, keep chasing the hype and buy new mods and tanks every month. Now that I can understand, as they probably always feel they missing something but will never get it.
Now the question. Us squonkers that have seen the light and have the best flavour and cloud and bigger than funny boepens 4ml tanks. What do we buy next? Is there really anything to buy that will, other than maybe better asthetics, give you anything better? So what do you spend your money on? Booze?
Now the question. Us squonkers that have seen the light and have the best flavour and cloud and bigger than funny boepens 4ml tanks. What do we buy next? Is there really anything to buy that will, other than maybe better asthetics, give you anything better? So what do you spend your money on? Booze?
Single coil rda flavour chasers is all i got after now days. I have found a ok place.
Oh and i buy more and more squonk mods just cause
diy juice now we make our own
Good question @Jean claude Vaaldamme
It does take a while for most vapers to find their "happy place" hardware wise. Then the hardware purchases tend to slow down a lot. Thats the position I am in. I dont buy new hardware often because im happy with what i have. But i do focus my attention on different coils to tweak the vape. And of course. The juice journey. I get very excited trying out a new juice for the first time. Love the juices and for me thats one of the great things that makes vaping so special, compared ro smoking.
You assume that Squonking is the pinnacle of vaping for everyone... that assumption is incorrect... I was squonking 4 years ago and have more than a few squonkers in my arsenal and a fair selection of RDA's... and for my style of vaping and the juice I use nothing comes close to a Dvarw DL on a DNA75C Mod.
Also chasing the hype is not limited to RTA's... Hype drives the vaping machine! Why else would there be a new RDA nearly every day? There is a lot of BF RDA's released each month and those are aimed at the Squonking Brigade.
Juice Choice is a MASSIVE factor in the type of setup you are happy with... some juices excel in an RTA at low power and others sparkle in an RDA at high power and then everything in-between. Single Coils, Dual Coils, RTA's, RDTA's, RDA's, Pod Systems... they all sell... why? Because each of us is different and while one person is happy with a Pod System others hate it...
Everyone is striving to find the perfect vape setup... and every time we discover a new coil that makes a difference or a new wicking material or a new tank we get closer... some like Hi Ho @Silver have found their happy place ages ago and are no longer on the hype train. Others like me feel I'm in my happy place but I love this game so much and I will continue to try anything and everything that comes around because it's my hobby and vaping saved my life!
Ok thanks, maybe I found my happy place then. But there is still an itch. Maybe then the itch is for a cigarette?
Noooooooooooooooooooooooooooo! Decent RTA with Red Pill rather!
Similar threads
