Vapor shark centre pin to low

[dannler]

Hey guys. So i got a vapor shark and the centre pin is to low. If i screw any rda or rta in with no adjustable centre pin then it doesnt make contact.

I have modded the centre pin to sit higher but its not a perfect mod. Where can i get another centre pin?

 

[andro]

A question ... What did u actually do to the center pin?

 

[dannler]

Stock, it had a groove about mid way up the pin shaft for the circlip to hold it down. What i did was cut a new groove about 2mm below the stock groove, allowing the pin to go higher and make contact. But its not the best of groove, and im worried it might short out.

 

[andro]

Did u buy an original shark? Asking because just checked mine and work with all atty

 

[dannler]

Dont know if its a clone or not. Got it off this forum

 

[gertvanjoe]

Well you could always sand down a 510 connector to sit "deeper" . Not the best of fixes I suppose but it should work

 

[dannler]

Yea maybe i should do that.

 

[dannler]

Just file some of the threads down on the connector, so that the rda's screw in ''deeper'' thanks man

 

[gertvanjoe]

cool

Sent from my GT-I8190 using Tapatalk