Vaporesso Transformer RDA

[Andre]

@BigGuy, the atty came early this morning. Thanks for the amazing service.

So I tried something a little different today... A postless deck is new to me. Messed up a pair of coils because I cut the legs too short. Going to keep those for my velocity atomisers.

The second try round you learn how to measure the leg length and position the coils. Used 28ga 316l SS. Dual coil. 9 wraps each ending off at around 0.5ohm

Winning.

Then, while wicking, I realised that postless is perfect for squonking because you can use one long piece of cotton to create a ring of cotton around the barrel. (see my pic attached) I then tucked the ends of the single piece of cotton I used to wick this under the leads so they definitely can't touch the deck. I had to trim down and thin the ends quite a bit to get this to look how I wanted.

Saving the vape for tomorrow when my bf Therion gets here... But I have high hopes.

What do you guys think? Good/bad wicking method? Think it'll work and saturate properly?

With squonking less cotton is usually better as a general rule. Wick tails can be short, barely touching the deck.

 

[spiv]

With squonking less cotton is usually better as a general rule. Wick tails can be short, barely touching the deck.

Thanks @Andre.

Seems like shorter wicking is the best way. I'll cut it down and give that a bash instead.

 

[Moey_Ismail]

Thanks @Moey_Ismail. The 2 ends to feed from makes a lot of sense. Do you know why this deck need the coils close to it?

I managed to get the coils lower than Flo Rider's shorty. If this doesn't wick nicely, rewicking shouldn't take long.
I'll only get a chance to try it out a bit later today but will come back with my impressions tonight after using it a bit.

It doesn't really need it close but you are squonking so take advantage of your whole coil getting juice instead of just the wick ends, you'll get a great dense saturated vape, a good safe height would be to rest the mandrel or rod you using to install the coils right on that outer lip

 

[Kalashnikov]

Anyone tried single coils on this thing?Wanna use it with the BF pin

 

[spiv]

Anyone tried single coils on this thing?Wanna use it with the BF pin

Not sure how great the single coil airflow will be, but it's possible.

I use this as a squonking atty exclusively. It works really great.