Pre-chop, top removed
First cut
Little progress, lots of noise...
Bulk of the work finished
All done, now just needs a tidy up
Cutting stones
510 pin removed. The white grommet is the faulty bit. You can just make out the tear in the grommet which seems to make it short out and give the dreaded VTR 'Non' error.
Check the pin, firmed up with 3mm O rings. This config didnt work, and I managed to get it fixed with 2 3mm o rings and some heat shrink
First cut
Little progress, lots of noise...
Bulk of the work finished
All done, now just needs a tidy up
Cutting stones
510 pin removed. The white grommet is the faulty bit. You can just make out the tear in the grommet which seems to make it short out and give the dreaded VTR 'Non' error.
Check the pin, firmed up with 3mm O rings. This config didnt work, and I managed to get it fixed with 2 3mm o rings and some heat shrink