I said dont spend ALL your money, not spend nothing...
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: this_feature_currently_requires_accessing_site_using_safari
This chart is NOT to work out the wattage on a mech. It is a chart for the Cana 30W, which has a minimum output voltage of 4.0V. It tells you the minimum wattage required for a range of resistances to attain that minimum output voltage. Thus, giving you an indication of which resistance coils to buy or build for your preferred wattages.Use this chart to workout the wattage on a mech, it all depends on the build you use.
View attachment 9124
Sent from my S4 LTE using my finger
Hi @bwbwings
I hear you
I think it will help if you can try answer the following...
Are you after more throat hit or more flavour?
What juices have you tried? At what strengths?
What atomiser are you using at the moment on your ego?
When last did you change coils?
Hi @bwbwings
Its very tempting for me to jump out quick and say go buy this or that and you will be sorted
But by the sounds of it, you have tried quite a lot (atomiser wise) and juice wise still with no luck.
I will say that many folk have quitted stinkies on the same type of gear that you have tried.
So can understand why you feel demoralised.
But dont wory, if there is a will, there is a way
You are probably right, you need more power.
The way i see it, you have two types of routes:
A) the non-rebuildable route - Nautilus mini and say SVD at a minimum (15 watts of power). Or something more expensive like the Sigelei 20w or 30w or the Hana/cana. Advantage of the 20W or 30w is should you decide to go rebuildable later and want more power, you can
B) the rebuildable route - here the options are endless. If you get a good kayfun type clone that is known to work well, then that can work. Many are happy with that. Powering that up can be done relatively cheaply with a mech like a nemesis or similar. But you could alway use a regulated higher power device too in option A) above if you went for that.
The above are options to consider that will most likely give you a better vape than wht you have now. But finding something that is practical and can be used as a daily workhorse to suit your style is another matter.
Personal preference also comes in to play as well. Its hard to know what you prefer until you've tried it out for a while.
Hoping you can find something that works for you and that you are happy with. You are going about it the right way by doing your research, considering the options and asking for advice.
Have done a bit of Googling and from what I infer the minimum output voltage of the Sigelei 20 and 30W is 3.1V in real life. That is quite low and will easily give you the lower power ranges should you desire - of course the higher power ranges is available as well. The Cana 30W is 4.oV, which is high - if you have a lower resistance coil on it, you might not get to the lower power you might desire. The IPV 50 W is 3.7V, which will give you access to intermediate power ranges.
Thus, if on you Twists you have only been using the lower settings, go for a Sigelei. If you have been using the higher settings exclusively, the IPV 50W is a good bet.
HRH is using the IPV 50W with a Mini Nautilus. The coils for the Mini Nautilus is 1.8 ohms, but the IPV reads it as 2.0 ohms, allowing HRH to go down to 7W (3.7V). This is working perfectly for her. This Mini Nautilus can, however, be vaped at very high power as well and the IPV 50W is also perfect for rebuildables, if that is in your future.
Taken all you have said above into consideration, my recommendation for you would be the IPV 50W with a Mini Aspire Nautilus. As far as I know only www.vapeclub.co.za stocks the IPV 50 W. They also have the Mini Nautilus and replacement coils for it. Here is a picture of HRH's setup.
Wow Andre, that is alot to absorb. Thank you for taking the time to lay it out like that.
I am not too sure between higher power and lower power, all I know is I screw on a mPt2 twist the voltage until I get a semi-decent vape and hope it all works.
These hight power options are fairly new to me, thus I am so torn.
What would you recommend between the Sigelei 30w vs the IPV 50w? Quality of build, etc?
I have never had a Sigelei. @Rob Fisher has one and is most satisfied. From what I have seen on the Internet they are solid mods. Had a Cana 30W and have an IPV 50W, prefer the IPV 50 for quality of build, looks and the lower minimum output voltage. In principle, I prefer box mods - they will stand on the table and not roll around. Of course, it will be amiss of me not to mention above all of these, a Reo is the best.Wow Andre, that is alot to absorb. Thank you for taking the time to lay it out like that.
I am not too sure between higher power and lower power, all I know is I screw on a mPt2 twist the voltage until I get a semi-decent vape and hope it all works.
These hight power options are fairly new to me, thus I am so torn.
What would you recommend between the Sigelei 30w vs the IPV 50w? Quality of build, etc?
One would never guess that from your avatar.And just to throw a spanner in the works... I used a mate's cana and prefer my eVic over it. They are all great mods, my preference is cylindrical. In other words you would probably not go wrong with any of your choices.
Great advice from real practice. Would love to hear how your mAN fares on the Sigelei.Hi @bwbwings
I have a Sigelei 20W, it was my 1st big buy on my vape journey and i don't regret it one moment. The majority of the weight seems to be more in the bottom so that it does not fall over so easy but if you push it it will fall. Build quality is outstanding
The vape:
On my mPT2 with stock coils 2 Ohm DIY 50/50 juice the coil does not wick fast enough and over 9watt you get a burned taste after the second drag. With my own build coils. 1.2ohm Rayon wick i can push it a bit more to 11 watt
What i like is when i want to taste some juice i just made, i pop my iGoW on there push the Sigelei to 20 watt and the iGo purs like a kitten
Battery last me about 36hours if i just use the tanks with my own coil. Green panasonic (it think 3200mah)
Great advice from real practice. Would love to hear how your mAN fares on the Sigelei.
Presume you mean "cannot wait"....for it to arrive?That was my 2nd big buy and can wait
Presume you mean "cannot wait"....for it to arrive?