First Coil Rebuild Aerotank

[andro]

It glow red all of it .was not too difficult . Only thing gurgle a bit compared to the stock one . Will try again soon

 

[thekeeperza]

Was that a single coil build?

 

[andro]

Yes single

 

[Gizmo]

Very neat. Pity its not vaping how it looks it should

 

[andro]

Very neat. Pity its not vaping how it looks it should

What u mean ?

 

[Gizmo]

The gurgling.

 

[thekeeperza]

Gurgling could be wick related. You will have to try put more wick material in - similar amount to the coil it comes with

 

[andro]

Ok understood. I must say that i just tried for few puffs and started to get ready to go to work .
It may change

 

[andro]

I used a 2.2 mm surgical needle . And 2 mm wick . I will try with a smaller needle

 

[thekeeperza]

You might have to add a layer or 2 of wick on top of the coil

 

[thekeeperza]

check here

 

[Gazzacpt]

You might have to add a layer or 2 of wick on top of the coil

Yup I normally put two 2mm silica wicks over the coil. One piece only for thicker juice or 2 1mm pieces. Its trial and error to get it to your liking.

Sent from my GT-I9190 using Tapatalk

 

[BhavZ]

When it comes to evod coils and silica wicks flavour wicks are almost always a must. With Cotton the edge of the wicks where the slits are in the cups swell up nicely and that prevents the gurgling.

 

[TylerD]

Good work Andro!

 

[Hein510]

Nice man! Maybe try popping off the topcap and just put a small piece of rolled up cotton over the coil and pop the topcap back on, then you have silica and cotton wicks in 1 coil, silica feeds the coil and cotton stops the gurgle

Sent from my BlackBerry 9800 using Tapatalk

 

[andro]

Will modify later tonigth and try again thanks guys