Help needed with building coils

Harley Vaper

Noob Vaper
LV
4
 
Joined
11/5/16
Posts
15
Awards
6
Age
50
Location
Gauteng
Hi Guys,

I am quite new to this and have just fitted the RBA coil that came with my CUBIS atomizer - wow what an improvement on the std coils, even though it is also a 0.5ohm coil.

So my question is, I would like to rebuild this coil once it is done and would like to end in the 0.3-0.4ohm range, which gauge wire should I buy?

I am using an e Vic mini.

Thank you
 
Use steam-engine... Awesome tool to dial in your builds


Sent from my iPhone using Tapatalk
 
ive built a 0.38ohm single coil 5 wrap Kanthal into a Subtank
if this helps

Using 26g
 
Hey guys. I think I'm coming close to finding my sweet spot. I hope so at least. Need some advice on coil builds please. I am using stainless steel 24g. 9 wraps 3mm dual coil and slightly spaced to be in line with the posts on the Genesis. With my settings on the rx200 in temp control. 60w and 290 degree Celsius. I find I'm getting great flavor and decent cloud but I am getting quite a bit of spit back. I gather this is from the wattage but going lower and I lose flavour. Any suggestions on how to build a decent coil for a flavour full and warm vape?
 
Here is another build

26g
Nicrothal80
0.42 ohm

My build was Dual vertical build.
Roughly
0.7 each coil.
@ 9 wraps
 

Attachments

  • subtank5.jpg
    subtank5.jpg
    59.6 KB · Views: 17
  • subtank4.jpg
    subtank4.jpg
    40.5 KB · Views: 17
  • subtank3.jpg
    subtank3.jpg
    44.5 KB · Views: 14
  • subtank1.jpg
    subtank1.jpg
    47 KB · Views: 19
  • subtank2.jpg
    subtank2.jpg
    14.5 KB · Views: 19
Back
Top