Help! Tank stuck on mod
- Thread starter RipeAvo
- Start date
Apparently...
Now its turning into a weapon and slicing through everything. Got some rubber gloves, cut right through them and sliced a few hands.
I feel like I should take it to the vape convention and offer a reward for whoever can separate it.
(I do not take responsibility for any injuries or amputation/s)
Now its turning into a weapon and slicing through everything. Got some rubber gloves, cut right through them and sliced a few hands.
I feel like I should take it to the vape convention and offer a reward for whoever can separate it.
(I do not take responsibility for any injuries or amputation/s)
i know you got some glass or perspex in your atomizer...but...
sometimes just a quick sharp smallish tap on a counter can help.
When the hammer mod came out, it had a habit of gluing itself to the kraken atty (or vice versa)..and sometimes all the screwing around would do nothing, but an innocent little tap..and tadaaa.
Just start with the least destructive method and work your way up.
So..chi-you clone...thats got an adjustable 2way centre pin. Perhaps, removing as many parts of the tubes as possible, and going in through the bottom and trying to turn the nut a bit to loosen the centre pin from below the atty could help.
sometimes just a quick sharp smallish tap on a counter can help.
When the hammer mod came out, it had a habit of gluing itself to the kraken atty (or vice versa)..and sometimes all the screwing around would do nothing, but an innocent little tap..and tadaaa.
Just start with the least destructive method and work your way up.
So..chi-you clone...thats got an adjustable 2way centre pin. Perhaps, removing as many parts of the tubes as possible, and going in through the bottom and trying to turn the nut a bit to loosen the centre pin from below the atty could help.
picture courtesy of fasttech...of a topcap i bought for chi-you
those two rings on the bottom turn in and out on each other...you want to somehow get the larger one and turn it anticlockwise. That should release pressure on the mod. which may help the atty unscrew.
The smaller one is the battery rattle adjustment...so perhaps get that out first as it should be loose-ish, then turn the other one out also. Then try removing the tank.
Last edited:
I use two pieces of electrical cable. Cut two pieces from an old apliance, about 30cm. Wrap one piece on the atty and one on the mod, then pinch it as close to the mod and atty as you can. This will give you super powers and you wont cut yourself.
Try dipping only the mod part in boiling water..
Similar threads
