REO - The Basics

So can this d100 one be used for the old contacts? :)

@Rob Fisher do you use it for batts and then also the Deoxit Gold for the contacts? Ie. these two conditioners mix?

Yes @chamberlane I would imagine so... that's pretty much how I do do it...

Just remember that the OLD non gold contacts are perfect candidates for the Nolax that comes with the REO's.
 
Hi guys,

My Reo (Thor) aint vaping good anymore.

I think it might be the battery's, the charger show they are fully charged but when I vape with them its like
they are almost dead. All the contacts are clean and shiny.

Do you think it is the battery's?
How many batteries have you been using and for how long?
 
@kimbo

On this setting : (pick)
It shows 4.23 on bouth battery's.
 

Attachments

  • image.jpg
    image.jpg
    303.8 KB · Views: 34
ok i see 9 months as well now, maybe they dont hold charge that well anymore

Yeah, only 2 in rotation and do not think they started off new with @annemarievdh (?). And they are 18490s or 18500s for Thor, the Reo Mini.

They are 18500 and nope, did not start of new with me. So you guys say I should try new battery's?
 
Just something from my side .. even if a tester shows that the batterys are 4.23 it does not mean that they are ok . They can have 4.23 volts but might still not be able to deliver the amps needed . Only way to know for sure is with a load test .:2c:
 
Good luck with that @annemarievdh
Hope it goes ok with the new batteries
Let us know
 
So I get the new battery's and charge them all up...

Time to get them in the Reo...

and

Nothing :doh:
 
So I get the new battery's and charge them all up...

Time to get them in the Reo...

and

Nothing :doh:

Take some clear photo's and I can try to diagnose the issue, but first off check the bottom earth screw (on the negative spring) to make sure it's getting a good contact with the raw aluminum.
 
So I get the new battery's and charge them all up...

Time to get them in the Reo...

and

Nothing :doh:
Oh my. That is not good. Check if the nipple below the firing plate is properly fastened - take the juice tube off. The spring has not collapsed so you battery is not making contact at the top?
Yes, pictures might help as @Alex said above.
 
Take some clear photo's and I can try to diagnose the issue, but first off check the bottom earth screw (on the negative spring) to make sure it's getting a good contact with the raw aluminum.

I will do that as soon as I get back home, have to go and get some pizza for dinner :D
 
So I get the new battery's and charge them all up...

Time to get them in the Reo...

and

Nothing :doh:

Take some clear photo's and I can try to diagnose the issue, but first off check the bottom earth screw (on the negative spring) to make sure it's getting a good contact with the raw aluminum.

Oh my. That is not good. Check if the nipple below the firing plate is properly fastened - take the juice tube off. The spring has not collapsed so you battery is not making contact at the top?
Yes, pictures might help as @Alex said above.
To add:

Did you perhaps apply nolax to the contacts, sometimes (if you're like me haha) when applying nolax I dab too much, which tends to misfire. A simple wipe on the all contacts and the Reo is thumping along again.

Also check if your atty is making a connection with the 510 pin and that the coil is still fine.
 
Last edited:
Back
Top