What's in your hand right now?

O frame with the csmnt v2.
912ea0ab1e484e1c6e82c403bd00d86f.jpg


Sent from my DUB-LX2 using Tapatalk
 
Yea.
I think the Wismec RX Gen3 Dual is still the smallest dual regulated.
:)
I was talking pacifically DNA250C, i can think of a few a bit smaller with a proprietary chipset!
 
Sucking on this while watching Netflix, delicious freezy pineapple bliss:wasntme:
 

Attachments

  • 16139275803133777586122358829586.jpg
    16139275803133777586122358829586.jpg
    272.1 KB · Views: 44
Awesome coffee freezo with the newly acquired DotAio with RBA and some trinity 12mg, 0.65ohm coil but feel like it's underpowered on full go mode. Still getting the right build in it.
Any advice on build and wicking for this RBA.
20210221_123334.jpg
 
Last edited:
Snap, crackle and popping awesome flavour with one of @charln's MTALIEN masterpieces!!!!!! Build starting to quiet down but the flavour is very impressive!!!!!!!!

IMG_6181.JPG
 
Awesome coffee freezo with the newly acquired DotAio with RBA and some trinity 12mg, 0.65ohm coil but feel like it's underpowered on full go mode. Still getting the right build in it.
Any advice on build and wicking for this RBA.
View attachment 223144
Hi @CashKat88 , I had the same problem, very little flavour and felt underpowered , the reason it feels underpowered is because this should be approached as a mech were you build for a certain vape. Right now I have vandy vape super fine mtl Clapton in 2.5 x 5 wraps and it's ready .65 I cut the legs at 4mm and remember to wrap opposite to every other rda. Then check out churches vaping doing his build, I cut my wicks into a point then I cut about 1/3rd of it off of the thickness, length just sticks out the bottom. If you need picks please let me know, can send for you to help explain
 
Hi @CashKat88 , I had the same problem, very little flavour and felt underpowered , the reason it feels underpowered is because this should be approached as a mech were you build for a certain vape. Right now I have vandy vape super fine mtl Clapton in 2.5 x 5 wraps and it's ready .65 I cut the legs at 4mm and remember to wrap opposite to every other rda. Then check out churches vaping doing his build, I cut my wicks into a point then I cut about 1/3rd of it off of the thickness, length just sticks out the bottom. If you need picks please let me know, can send for you to help explain
Thanks so much mate I'll take another crack at it tomorrow, if you do have pics, it would be appreciated. Thanks so much
 
Back
Top